@article{Ruppert2021,

title = {Active atomic force microscope cantilevers with integrated device layer piezoresistive sensors},

author = {M. G. Ruppert and A. J. Fleming and Y. K. Yong},

url = {https://www.precisionmechatronicslab.com/wp-content/uploads/2021/01/J21a.pdf},

doi = {10.1016/j.sna.2020.112519},

issn = {0924-4247},

year  = {2021},

date = {2021-01-19},

urldate = {2021-01-19},

journal = {Sensors & Actuators: A. Physical},

volume = {319},

pages = {112519},

abstract = {Active atomic force microscope cantilevers with on-chip actuation and sensing provide several advantages over

passive cantilevers which rely on piezoacoustic base-excitation and optical beam deflection measurement. Active

microcantilevers exhibit a clean frequency response, provide a path-way to miniturization and parallelization and

avoid the need for optical alignment. However, active microcantilevers are presently limited by the feedthrough

between actuators and sensors, and by the cost associated with custom microfabrication. In this work, we propose

a hybrid cantilever design with integrated piezoelectric actuators and a piezoresistive sensor fabricated from the

silicon device layer without requiring an additional doping step. As a result, the design can be fabricated using a

commercial five-mask microelectromechanical systems fabrication process. The theoretical piezoresistor sensitivity

is compared with finite element simulations and experimental results obtained from a prototype device. The

proposed approach is demonstrated to be a promising alternative to conventional microcantilever actuation and

deflection sensing},

keywords = {},

pubstate = {published},

tppubtype = {article}

}

@article{McCourt2020,

title = {A comparison of gold and silver nanocones and geometry optimisation for tip-enhanced microscopy},

author = {L. McCourt and M. G. Ruppert and B. S. Routley and S. Indirathankam and A. J. Fleming},

url = {https://www.precisionmechatronicslab.com/wp-content/uploads/2020/09/J20e.pdf},

doi = {https://doi.org/10.1002/jrs.5987},

year  = {2020},

date = {2020-11-01},

urldate = {2020-08-24},

journal = {Journal of Raman Spectroscopy},

volume = {51},

issue = {11},

pages = {2208-2216},

abstract = {In this article, boundary element method simulations are used to optimise the geometry of silver and gold nanocone probes to maximise the localised electric field enhancement and tune the near-field resonance wavelength. These objectives are expected to maximise the sensitivity of tip-enhanced Raman microscopes. Similar studies have used limited parameter sets or used a performance metric other than localised electric field enhancement. In this article, the optical responses for a range of nanocone geometries are simulated for excitation wavelengths ranging from 400 to 1000 nm. Performance is evaluated by measuring the electric field enhancement at the sample surface with a resonant illumination wavelength. These results are then used to determine empirical models and derive optimal nanocone geometries for a particular illumination wavelength and tip material. This article concludes that gold nanocones are expected to provide similar performance to silver nanocones at red and nearinfrared wavelengths, which is consistent with other results in the literature. In this article, 633 nm is determined to be the shortest usable illumination wavelength for gold nanocones. Below this limit, silver nanocones will provide superior enhancement. The use of gold nanocone probes is expected to dramatically improve probe lifetime, which is currently measured in hours for silver coated probes. Furthermore, the elimination of passivation coatings is expected to enable smaller probe radii and improved topographical resolution.},

keywords = {},

pubstate = {published},

tppubtype = {article}

}